Service of Audi A4 from 2001 to 2005 release.
1. Operation and maintenance of the car
2. Engine
2.1. General information
2.2. Predvaritlny checks
2.3. Mekhanichsky part (petrol engines 2,0l)
2.3.1. Removal of the engine
2.3.2. Removal and installation of a poliklinovy belt
2.3.3. Removal and installation of a belt pulley of the crankshaft
2.3.4. Removal and installation of a gear belt
2.3.5. Removal and installation of a sealing flange and flywheel / the conducted disk
2.3.6. Replacement of manzhetny consolidation of the crankshaft on the party of a belt pulley
2.3.7. Removal and installation of a forward sealing flange
2.3.8. Removal and installation of a two-mass flywheel
2.3.9. Removal and installation of the conducted disk
2.3.10. Removal and installation of a bent shaft
2.3.11. Removal and a press fitting of the needle bearing in the crankshaft
2.3.12. Removal and installation of an asterisk
2.3.13. Dismantling and assembly of pistons and rods
2.3.14. Head of the block of cylinders
2.3.15. Removal and installation of the valve of 1 system of change of phases of gas distribution
2.3.16. Removal and installation of a cover of a head of the block of cylinders
2.3.17. Removal of a head of the block of cylinders
2.3.18. Installation of a head of the block of cylinders
2.3.19. Check of a compression
2.3.20. Repair of the valvate mechanism
2.3.21. Removal and installation of the phase shifter
2.3.22. Removal and installation of cam-shafts
2.3.23. Replacement of oil scraper caps (at the established head of the block of cylinders)
2.3.24. Check of the directing plugs of valves
2.3.25. Replacement of manzhetny consolidation of a final cam-shaft
2.4. Lubrication system
2.5. Cooling system
2.6. System of injection
2.7. System of production of the fulfilled gases
2.8. Mechanical part (petrol engines 3,0; 3,2 l)
2.9. Mechanical part (petrol engines of 4,2 l)
2.10. Mechanical part (diesel engines of 2,0 l)
2.11. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment
 

2-3-5-snyatie-i-ustanovka-uplotnitelnogo-flanca-i-makhovika-vedomogo-diska.html

2.3.5. Removal and installation of a sealing flange and flywheel / the conducted disk
Fig. 2.108. Sealing flange and flywheel: 1 – bolt of 15 N · m; 2 – sealing cuff; 3 – forward sealing flange; 4 – block of cylinders; 5 – a bolt of fastening of a two-mass flywheel / the conducted disk; 6 – a two-mass flywheel and the conducted disk; 7 – intermediate guard; 8 – bolt of 15 N · m; 9 – a back sealing flange with an epiploon


Fig. 2.109. Installation of an intermediate guard

Establish an intermediate guard (fig. 2.109).
Suspend an intermediate guard on a sealing flange and get on adjusting plugs.

2.3.4. Removal and installation of a gear belt
2.3.6. Replacement of manzhetny consolidation of the crankshaft on the party of a belt pulley