|
2-9-6-snyatie-i-zapressovka-igolchatogo-podshipnika-v-makhovik.html
2.9.6. Removal and a press fitting of the needle bearing in a flywheel
|
|
Fig. 2.401. Components of a two-mass flywheel: 1 – two-mass flywheel; 2 – needle bearing; 3 – special bolt; 4 – bent shaft; 5 – a crankshaft epiploon from the chain drive
|
Remove press a clutch plate.
Take the needle bearing by means of an internal stripper and a countersupport (fig. 2.314).
Press the needle bearing in a two-mass flywheel by means of a mandrel against the stop (fig. 2.315). Establish press a clutch plate.
|