4.3.5. Removal of a screw spring

Fig. 4.61. Compression of a spring coupler

Clamp a depreciation rack in a vice (fig. 4.61).

Squeeze a screw spring by means of a coupler of a spring and capture so that the top cup of a spring was released.

Fig. 4.62. Correct landing of a spring

Provide appropriate landing of a twisted spring in captures (fig. 4.62).

Turn off a nut with a flange from a rod by means of special tools.

Remove separate details of a depreciation rack and the compressed spring by means of a coupler of a spring (fig. 4.61).

Replace the shock-absorber.

Fig. 4.63. The correct provision of the lower plate of a spring in relation to the shock-absorber

Remove a protective cap 1 and the lower support of a spring of 2 (fig. 4.63).

Note the provision of the lower plate of a spring in relation to the shock-absorber.

Weaken a plate of a spring 3 by means of the plastic hammer and remove in the direction up.

Fig. 4.64. Assembly provision of the lower plate of a spring

A A shock-absorber screw axis / the bearing lever.

I = at the left, B = 65 2 .

II = on the right, C = 87 2 .

Blows of the plastic hammer push a plate of a spring on the drawn mark down.

At installation of a new damper transfer a mark from an old damper.

You monitor various provision from the left and right side.

The cut in a plate of a spring has to provide a free wheeling to a body.