Service of Audi A4 from 2001 to 2005 release.
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
4.1. Wheels and tires
4.1.1. General information on wheels and tires
4.1.2. Specifications for re-equipment of disks and tires
4.1.3. Indexes of speed of tires
4.1.4. Marking on disks
4.1.5. Compound disks
4.1.6. Wear and hodimost of tires
4.1.7. Wear of high-speed tires
4.1.8. Service of tires
4.1.9. Evenly worn-out tires
4.1.10. Measurement of height of the drawing of a protector
4.1.11. Unilateral wear
4.1.12. Diagonal uneven wear
4.1.13. Noise of swing of tires
4.1.14. Balancing
4.1.15. Radial and side beating of wheels and tires
4.1.16. Check of a radial and side beating of a disk with the tire by means of the indicator of hour type for tires V.A.G 1435
4.1.17. Minimization
4.1.18. Side withdrawal of the car
4.1.19. Elimination of side withdrawal
4.1.20. Damages of tires
4.1.21. Design of the radial tire
4.1.22. Loss of pressure of air in tires
4.1.23. Damages of tires because of mistakes when mounting (assembly damages)
4.1.24. Marking of a sidewall of the tire
4.1.25. Shift of wheels
4.1.26. Instructions on replacement and installation of wheels
4.1.27. Change of tires
4.1.28. Removal and installation of the case of the metal gate
4.2. General information about a running gear of the car
4.3. Repair of a suspension bracket of forward wheels
4.4. Back suspension bracket
4.5. Tables
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment
 







4-1-27-smena-shin.html

4.1.27. Change of tires

At each change of tires it is necessary to change the nickelized gate zolotnik.
The metal gate and the electronic equipment of a wheel can be reused.
Take off pressure in the tire, having unscrewed the nickelized gate zolotnik.
Dismantle the tire.
Execute visual control on the weakened or damaged parts. At the weakened threaded connections replace all valve knot.

NOTE
Always replace the damaged electronic equipment of a wheel.

Mount the tire.
Twist the new, nickelized gate zolotnik.
To pump up the tire, again to twirl a plastic cap.
Execute balancing of the tire.

Balancing
Dismantle the tire
Roll the tire or wring out.
When using squeezing shovels at first wring out the tire on the party, opposite from the gate.

Fig. 4.32. The site on which wheel shovels are not applied


Do not apply squeezing shovels in the shaded an area (fig. 4.32).
Squeezing head arrange near the gate so that it was possible establish an assembly shovel in 30 ° (b) near the gate.
Only then wring out the tire in the field of the gate.

Installation of the tire
Do not apply squeezing shovels in the field of the gate.

Fig. 4.33. Cave-in of the tire


Install the electronic equipment of a wheel about 180 ° against a squeezing head (fig. 4.33).
Press the tire into rim depth in a point, about, 90 ° from a squeezing head.
Mount the tire.


4.1.26. Instructions on replacement and installation of wheels

4.1.28. Removal and installation of the case of the metal gate