|
3-3-7-snyatie-i-ustanovka-privoda-vklyucheniya-peredach.html
3.3.7. Removal and installation of the drive of inclusion of transfersRemoval
Remove the automatic transmission selector handle.
Open an ashtray on the average console and remove the panel (fig. 3.94). Remove the module of management of the conditioner.
Remove an ashtray of the average console
|
|
Fig. 3.95. Removal of the panel of the selector
|
Unblock in total 4 clips and remove the panel 1 together with a guide in the direction (fig. 3.95) up. Pull out the shtekerny socket from a guide.
|
|
Fig. 3.96. Detachment of the shtekerny socket of an electromagnet of blocking of the automatic transmission selector
|
Disconnect the shtekerny socket of an electromagnet of blocking of the automatic transmission selector (fig. 3.96). Remove the lock.
|
|
Fig. 3.1. Fastening of a noise isolation
|
Open latches 2 and 3 and remove a back part of a noise isolation (fig. 3.1).
Cars with the 4-cylinder engine
Remove internal left and right overlays of a floor of the car.
|
|
Fig. 3.97. Fastening of a back cross-piece of a floor
|
Remove a back cross-piece of a floor of the car, for this purpose turn off bolt connections of 1-4 (fig. 3.97).
All cars
|
|
Fig. 3.98. Fastening of a forward cross-piece of a floor
|
Remove a forward cross-piece of a floor of the car, for this purpose turn off bolt connections of 1-6 (fig. 3.98).
|
NOTE
In the figure 3.98 the car with the 4-cylinder engine is represented.
|
|
NOTE
It is impossible to bend a demountable element of a reception pipe more than on 10 ° – there is a danger of damage.
|
Separate system of release of OG on the fixing plug.
|
|
Fig. 3.99. Fastening of the heat-shielding screen
|
Remove the heat-shielding screen (fig. 3.99) located under the drive of inclusion of transfers. Turn off the lower cover from the drive of inclusion of transfers.
Remove a cuff of a cable of the automatic transmission selector from the lower cover and remove it back.
|
|
Fig. 3.100. Removal of a stopper of a cable of the automatic transmission selector of the drive of inclusion of transfers
|
Remove in the direction a stopper of 1 cable of the automatic transmission selector of the drive of inclusion of transfers (fig. 3.100) down. Push a plastic safety spring 2 a little forward and press on a bolt 3 so as far as it is necessary.
Pull out a cable of the selector of the check point 4 of the drive of inclusion of transfers.
|
NOTE
Do not bend and do not break a check point selector cable.
|
Turn off nuts.
|
NOTE
Removal of the drive of inclusion of transfers under the car requires presence of the assistant.
|
|
|
Fig. 3.101. Removal of the drive of inclusion of transfers
|
Press inside fixing brackets 1 and 2 and at the same time press down on the drive of inclusion of transfers (fig. 3.101).
Installation
Installation is carried out in the return sequence.
Establish an automatic transmission selector cable.
Install the lock.
Adjust the lock.
Install system of release so that in it there was no internal tension.
Check the drive of inclusion of transfers.
Inhaling moments
The drive of inclusion of transfers to a body: 10 N · m.
The lower cover to the drive of inclusion of transfers: 10 N · m.
Forward cross-piece to a car floor: 55 N · m.
Back cross-piece to a car floor: 60 N · m.
|