7.5.6. Removal and installation of the 3-nested block of the relay
Switch off ignition and pull out the ignition key.
Remove a ware compartment from the driver.
|Fig. 7.95. Fastening 3-nested block of the relay
Unscrew screws 1 and remove the 3-nested block of the relay 2 (fig. 7.95)
Poses. 3 and 4 do not take into account.
Disconnect blocks of safety locks from the 3-nested block of the relay (fig. 7.96)
Take the relay, control units, and then unblock the corresponding payment of the relay.
Establish in the return sequence.
Establish a ware compartment from the driver.
The 3-nested block of the relay to the central pipe of the forward panel: 3 N · m.