7.4.1. Removal and installation of a starter (cars with 4-tsit. petrol engine of 1,6 l, turbocharged engine of 1,8 l, MPI of 2,0 l and FSI 2,0 l)
Disconnect a weight wire in the accumulator at the switched-off ignition.
In cars with an autonomous heater unscrew screws of an exhaust pipe of an autonomous heater and additional heater on the noise-insulating screen.
|Fig. 7.61. Fastening of power supply of a starter
Release screws or quick disconnect clamps 1 and 2 and remove the forward noise-insulating screen (fig. 7.61)
Turn off a wire of the B+ 2 plug.
Where is available, remove the insulator on the plus plug of a starter.
Turn off fastening of an arm of a starter on the block of cylinders 3 and on a starter.
Remove a starter down.
Establish in the return sequence.
Connect the accumulator.
Starter to the transmission:
– M10: 45 N · m;
– M12: 65 N · m.
The B+ plug to a starter: 16 N · m.