1.2.11. Lifting and movable panel of a roof

Fig. 1.28. Rotary switch of the lifting and movable panel of a roof

Control of the lifting and movable panel of a roof is exercised of the rotary switch (fig. 1.28). For moving away / panels the switch can be installed in slightly fixed provisions. The switch works only at the included ignition. Raising of the panel is possible only when finding the switch in situation 0.

It is possible to open and close the lifting and movable panel of a roof within about ten minutes and after switching off of ignition. However the rotary switch of the lifting and movable panel of a roof is switched-off after opening of one of forward doors at once.

Turn the switch in situation 1 (fig. 1.28). The switch is noticeably fixed. This position of the panel of a roof is characterized by smaller noise of wind.

Turn the switch in situation 2 and hold it before full moving away of the panel of a roof.

Turn the switch in a starting position 0.

For full raising of the panel of a roof press and release the switch at its stay in a starting position.

For installation of the panel in an intermediate position press and hold the switch until the panel reaches necessary position.

At moving away of the panel of a roof the curtain protecting from solar influence automatically opens. At the closed roof panel the curtain can be closed also a hand.

The sun-protection curtain is recommended to be closed during the parking of the car in the sun. During the parking of the car or on a case of a sudden rain (at the closed sun-protection curtain) do not forget to close the lifting panel of a roof.

For closing of the panel of a roof turn the switch in situation 0.

Pull the back party of the switch and hold it until the lifting panel not to fall to necessary situation.

Short procrastination of the switch, the panel of a roof is closed automatically. Repeated short-term procrastination of the switch the panel can be stopped in any situation.

ATTENTION Inattentive or uncontrolled closing of the lifting and movable panel is fraught with emergency consequences Therefore at escape of the car always take out the ignition key from the lock.

From elements of the solar battery power supply of the conditioner in an operating mode of the fan is carried out.

The control of the panel of a roof matches the description given above.

The internal upholstery is rigidly connected to the roof panel with the solar battery and therefore it cannot be shifted separately.

In emergency the shifted panel of a roof can be closed by means of the electric drive.

The shifted panel of a roof has protection against overloads. If it does not manage to be closed in the normal mode, then it can be made by means of function of emergency closing.

Turn the switch in a starting position 0.

Pull and hold the switch so long, the shifted roof panel will not be closed yet.

In emergency the shifted panel of a roof can be closed mechanically.

Fig. 1.29. Screw-driver installation sites

Accurately insert the flat party of the screw-driver in the places shown in the figure 1.29.

Hook and separate plafond glass down.

Take the krivoshipny handle located from the inside of a cover of safety locks.

Fig. 1.30. The Krivoshipny handle for emergency closing

Insert the krivoshipny handle 1 against the stop into an internal hexagon 2, holding it at the same time (fig. 1.30).

Rotation of the krivoshipny handle close the roof panel.

After that establish plafond glass into place. At first plastic ledges are inserted into nests, and then glass nestles up.

NOTE The Krivoshipny handle of emergency closing rotates easier if to use the screw-driver handle as the help. For this purpose it is necessary to take from the screw-driver handle a core in the beginning, and then to put on the handle the krivoshipny handle.