4-4-2-snyatie-i-ustanovka-amortizatora.html
4.4.2. Removal and installation of the shock-absorberRemoval
On cars with Dynamic-Ride-Control (DRC II) empty and fill system.
Remove a wheel.
Remove a twisted spring.
Unscrew a nut 1 and take the screw (fig. without protective leaf).
Unscrew bolts 2.
NOTE
Loker of a wheel arch does not act.
|
Remove the shock-absorber.
Installation
Tighten screws 2.
NOTE
Replace screws and the self-stopped management nuts in drawings in cuts.
|
You monitor the provision of the lower fastening (fig. 4.107).
Rubber-metal hinges (saylent-blocks) have the limited working range of twisting. Therefore tighten threaded connections of levers only on the empty car
Delay screw connection 1 (the forward drive) or (four-wheel drive).
Establish a twisted spring.
Establish and tighten a wheel.
|